Please let us know in the comments section below.Is your carpet flat and lifeless?
, we found that these vanes were more than just a gimmick – they really do prevent most hair from becoming tangled around the brush bar..However, we found that thicker thread, such as from a thick rug, can still become tangled.
There’s also the chance of other obstructions preventing the brush bar from turning properly.. For these reasons, it’s important to know how to unblock the Motorbar and remove any obstructions..Step 1: Remove The Motorbar Brush Bar.Before we start, it’s important to note that the.
Motorbar brush bar is.You shouldn’t run it under a tap to remove dirt, like you would with.
the Dyson V10’s Soft Roller brush bars.
It’s also important to remove the brush bar from the floorhead before you try to clear any obstructions.. To remove the brush bar, unlock the bar’s end cap using a coin.Hold the vacuum over a bin, then pull the red lever back and upwards to release the trap door.
The cyclone will be pulled up to ensure less dirt is trapped in the bin.. Push the cyclone back down into its regular position.Dust often falls out when the cyclone clicks, so it’s best to do this with the vacuum still held over the bin.. Manually shut the trap door until it clicks.
Make sure to do this after the cyclone is back in place..The Dyson V7 Trigger handheld vacuum cleaner has the same bin design, so the emptying process is identical.. Related Article:.